Revitalizant EX120 MOTO is designed for antiwear protection, restoration and protection of engines of motor equipment with combined or separate lubricating system with capacity up to 1000 cm³ (for motorbikes, motorcycles, snowmobiles, personal watercrafts and household motor equipment, etc.).
Products is applied to motorcycles, motorbikes, snowmobiles, personal watercrafts and household motor equipment, lawnmowers, chain saws etc. Due to its by 20% greater* active agent’s concentration, Extreme Action 120% (EX120) Revitalizant possesses extended potential of worn surface restoration and antiwear protection.
* compared to XADO MOTO.
- – Restores worn surface of engine cylinders, eliminates microcracks and scratches
- – Increases and levels compression in cylinders
- – Protects friction surfaces against wear
- – Reduces fuel consumption considerably
- – Restores engine capacity up to factory values
- – Increases service life of an engine by 3 times
- – Decreases the level of toxic components in exhaust gases
- – Decreases noise sustanon 250 and vibration level
Application
Application instructions for engines with combined lubricating system:
- Introduce* the content of the syringe* into the petrol tank before fuelling
- Fill the tank with fuel
- Start the engine and let it idle for 2-3 min
- Operate the engine in normal mode
* It is recommended preliminary to dissolve the content of the syringe in a small amount of oil (20-30ml) at its temperature of exceeding +25°C.
Application instructions for engines with separate lubricating system:
- Warm up the engine to the normal operating temperature
- Empty the contents of the syringe into the oil filler neck
- Start the engine and let it idle for 2-3 min
- Operate the engine in normal mode
Note:
- – The compound is equally effective for application to two- and four-stroke internal combustion engines of all brands
- – Does not influence the wet clutch operation
- – It is not recommended to change oil in four-stroke internal combustion engines until the end of treatment
- – The treatment is considered complete after not less than 1,500 km of run (approx. 20 hours of engine operation)
- – If the engine capacity exceeds 1000 cm3 it is necessary to double the dosage
- – The revitalizant is compatible with any additives, metal conditioners, remetalizants irrespectively of its application sequence
- – Protective ceramic-metal coating is formed on the metal surface of any alloys. If the wear rate is close to 100%, the destroyed part are subject to replacement
Pack
Syringe 4ml XA 10037
Reviews
There are no reviews yet.